Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
regie:regie_plateau [2022/03/10 21:09] – [Accroche & Levage] mh | regie:regie_plateau [2023/04/14 15:36] (current) – [Noeud de Chaise] mh | ||
---|---|---|---|
Line 13: | Line 13: | ||
* Arrivée en haut, la personne qui accroche n'aura qu'à passer le crochet (dont la partie d' | * Arrivée en haut, la personne qui accroche n'aura qu'à passer le crochet (dont la partie d' | ||
* Le projecteur peut même être sécurisé avec une ellingue avant serrage du crochet puisque la guinde fournit alors un élément de sécurtié suffisant. | * Le projecteur peut même être sécurisé avec une ellingue avant serrage du crochet puisque la guinde fournit alors un élément de sécurtié suffisant. | ||
+ | |||
+ | |||
+ | La [[https:// | ||
+ | ==== Charges ==== | ||
+ | |||
+ | === Élingues === | ||
+ | |||
+ | Pour le calcul des CMU des elingues plusieurs paramètres sont à prendre en compte : | ||
+ | |||
+ | {{regie: | ||
+ | |||
+ | ++++ Tableau récap de valeurs pour une élingue en acier simple | | ||
+ | |||
+ | {{regie: | ||
+ | |||
+ | ++++ | ||
+ | |||
+ | === Rayon de courbure === | ||
+ | |||
+ | Le tableau ci-dessus démontre bien que le rayon de courbure minimale à respecter dépendra du type de câble/fil utilisé et de ses caractéristiques. | ||
+ | |||
+ | Néanmoins, une règle facile à retenir pour le cas de l' | ||
+ | |||
+ | Pour une documentation plus complète, voici un exemple du fabricant d' | ||
+ | |||
===== Structure Modulable ===== | ===== Structure Modulable ===== | ||
Line 34: | Line 59: | ||
| {{regie: | | {{regie: | ||
+ | ==== Alpine butterfly ==== | ||
+ | |||
+ | Think : UNDER / OVER / UNDER | ||
+ | |||
+ | Do three loops around your hand so the ends of the rope are facing opposing directions of your hands. Then take the middle loop and pull it **under** the bottom loop, then pull it **over** the other two loops then back **under** the two loops. | ||
+ | |||
+ | Tighten everything up. | ||
+ | |||
+ | This is a non-binding loop that can be made mid line, bear load in any direction and is commonly used as an attachment point, a grab handle or for hoisting. | ||
+ | You can also use it as an easy to remove attachment point : pass your rope over the point you want to attach (e.g. branch), make an alpine butterfly on one end and pass the other end through it, pull that end all the way through so the alpine butterfly now rests at the attachment point. One end is your fix point, the other end will let you pull the knot down when you're done. | ||
==== Noeud Plat / Noeud de Vache ==== | ==== Noeud Plat / Noeud de Vache ==== | ||