projets:jenny

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
projets:jenny [2022/04/25 22:19] – [Next Steps] mhprojets:jenny [2022/04/25 22:20] (current) – [Next Steps] mh
Line 130: Line 130:
   * Measure % offset on size to get exact dimensions -> print test part, measure, compensate x,y,z, print again   * Measure % offset on size to get exact dimensions -> print test part, measure, compensate x,y,z, print again
   * Update wiki with Marlin firmware (latest), a backup of Printer/Prusament profiles for prusa-slicer, etc..   * Update wiki with Marlin firmware (latest), a backup of Printer/Prusament profiles for prusa-slicer, etc..
-  * Buy [[https://fr.rs-online.com/web/p/alimentations-a-decoupage/1748146/|a compact power supply]] and integrate on Jenny's front underside/or side of frame 
   * Ground the frame to the power supply   * Ground the frame to the power supply
   * Run a printer safety check page according to RepRap Wiki   * Run a printer safety check page according to RepRap Wiki
  • projets/jenny.1650917955.txt.gz
  • Last modified: 2022/04/25 22:19
  • by mh