Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
| projets:jenny [2020/06/20 12:05] – [New Fan Duct] mh | projets:jenny [2022/04/25 22:20] (current) – [Next Steps] mh | ||
|---|---|---|---|
| Line 95: | Line 95: | ||
| I tested it out but the eMotronic board I ordered differs from the smoothieboard project in a few ways. First, the entire PCB was redesigned by eMotion Tech and most of the pin numbers were reaffected. Documentation of the eMotronic is at the time of writing rather poor and scarce. | I tested it out but the eMotronic board I ordered differs from the smoothieboard project in a few ways. First, the entire PCB was redesigned by eMotion Tech and most of the pin numbers were reaffected. Documentation of the eMotronic is at the time of writing rather poor and scarce. | ||
| - | I encountered some major problems with the Z motors and manual control rendering the board impossible to use. As I thought the board was defective I sent it back to shop for revision and testing. They found no fault on the stepper drivers so they sent it back. As it turns out the eMotronic board takes many liberties with the original smoothieboard design and is not an easy implementation on an i3-type architecture. | + | I encountered some major problems with the Z motors and manual control rendering the board impossible to use. As I thought the board was defective I sent it back to shop for revision and testing. They found no fault on the stepper drivers so they sent it back. |
| + | |||
| + | **As it turns out the eMotronic board takes many liberties with the original smoothieboard design and is not an easy implementation on an i3-type architecture.** | ||
| Jenny still runs on the good old Mega + Ramps with a 2.0+ marlin firmware. | Jenny still runs on the good old Mega + Ramps with a 2.0+ marlin firmware. | ||
| Line 120: | Line 122: | ||
| *Try some new gcode on print stop line 1050 of configuration_adv.h (try multiple successive commands) | *Try some new gcode on print stop line 1050 of configuration_adv.h (try multiple successive commands) | ||
| + | *Design some new PSU fasteners for the new PSU unit so it is fixed on the Z frame | ||
| Line 125: | Line 128: | ||
| * Lookout for resonance on the cooler radial fan | * Lookout for resonance on the cooler radial fan | ||
| - | * Upgrade to a smoothie board | ||
| * Measure % offset on size to get exact dimensions -> print test part, measure, compensate x,y,z, print again | * Measure % offset on size to get exact dimensions -> print test part, measure, compensate x,y,z, print again | ||
| * Update wiki with Marlin firmware (latest), a backup of Printer/ | * Update wiki with Marlin firmware (latest), a backup of Printer/ | ||
| - | * Buy [[https:// | ||
| * Ground the frame to the power supply | * Ground the frame to the power supply | ||
| * Run a printer safety check page according to RepRap Wiki | * Run a printer safety check page according to RepRap Wiki | ||