Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
projets:jenny [2022/04/25 22:19] – [Next Steps] mh | projets:jenny [2022/04/25 22:20] (current) – [Next Steps] mh | ||
---|---|---|---|
Line 130: | Line 130: | ||
* Measure % offset on size to get exact dimensions -> print test part, measure, compensate x,y,z, print again | * Measure % offset on size to get exact dimensions -> print test part, measure, compensate x,y,z, print again | ||
* Update wiki with Marlin firmware (latest), a backup of Printer/ | * Update wiki with Marlin firmware (latest), a backup of Printer/ | ||
- | * Buy [[https:// | ||
* Ground the frame to the power supply | * Ground the frame to the power supply | ||
* Run a printer safety check page according to RepRap Wiki | * Run a printer safety check page according to RepRap Wiki |