Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revisionLast revisionBoth sides next revision | ||
| projets:jenny [2022/03/23 09:58] – [eMotronic (Smoothieboard) mainboard] mh | projets:jenny [2022/04/25 22:19] – [Next Steps] mh | ||
|---|---|---|---|
| Line 122: | Line 122: | ||
| *Try some new gcode on print stop line 1050 of configuration_adv.h (try multiple successive commands) | *Try some new gcode on print stop line 1050 of configuration_adv.h (try multiple successive commands) | ||
| + | *Design some new PSU fasteners for the new PSU unit so it is fixed on the Z frame | ||
| Line 127: | Line 128: | ||
| * Lookout for resonance on the cooler radial fan | * Lookout for resonance on the cooler radial fan | ||
| - | * Upgrade to a smoothie board | ||
| * Measure % offset on size to get exact dimensions -> print test part, measure, compensate x,y,z, print again | * Measure % offset on size to get exact dimensions -> print test part, measure, compensate x,y,z, print again | ||
| * Update wiki with Marlin firmware (latest), a backup of Printer/ | * Update wiki with Marlin firmware (latest), a backup of Printer/ | ||
| - | * Buy [[https:// | + | * Design custom parts to integrate |
| * Ground the frame to the power supply | * Ground the frame to the power supply | ||
| * Run a printer safety check page according to RepRap Wiki | * Run a printer safety check page according to RepRap Wiki | ||