Differences

This shows you the differences between two versions of the page.

--- composants:rpi_proxi_sensor [2020/06/22 22:07] – [Wiring] mh
+++ composants:rpi_proxi_sensor [2020/06/23 20:32] (current) – [Steps] mh
@@ Line 16: / Line 16: @@
 {{composants:sharp_mcp_wiring.png?400}}
-<WRAP 40%>
+<WRAP 50%>
 |^  RPi Pin #^   ^Role  ^  MCP3008 Pin #^  ^Role  |
 |  1|    |3.3V|  16|  |VDD  |
@@ Line 27: / Line 27: @@
 |  6|    |GND  |  9|  |DGND  |
 </WRAP>
+There are two different wirings, this one is for hardware SPI. Another one is used for software SPI
 {{composants:mcp3008pin.jpg?250}}
+===== Steps =====
+  *Installed raspbian
+  *Activated SPI in raspi-config
+  *wired a MCP3008 and a sharp IR module to the GPIO pins
+  *followed tuto on python but did not get data from module (read 0.00)
+  *rewired to software SPI (needs documenting)
+  *installed rust in tty with lightdm stopped
+<code bash>
+curl --proto '=https' --tlsv1.2 -sSf https://sh.rustup.rs | sh
+</code>
+  *reboot to activate rust
+  *
 ===== Ressources =====
   *[[https://tutorials-raspberrypi.com/infrared-distance-measurement-with-the-raspberry-pi-sharp-gp2y0a02yk0f/|Blog post Tutorial]]