composants:rpi_proxi_sensor

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
Last revisionBoth sides next revision
composants:rpi_proxi_sensor [2020/06/22 22:07] – [Wiring] mhcomposants:rpi_proxi_sensor [2020/06/23 20:24] – [Steps] mh
Line 27: Line 27:
 |  6|    |GND  |  9|  |DGND  | |  6|    |GND  |  9|  |DGND  |
 </WRAP> </WRAP>
 +
 +There are two different wirings, this one is for hardware SPI. Another one is used for software SPI
  
 {{composants:mcp3008pin.jpg?250}} {{composants:mcp3008pin.jpg?250}}
 +
 +===== Steps =====
 +
 +  *Installed raspbian
 +  *Activated SPI in raspi-config
 +  *wired a MCP3008 and a sharp IR module to the GPIO pins
 +  *followed tuto on python but did not get data from module (read 0.00)
 +  *rewired to software SPI (needs documenting)
 +  *installed rust <FAILED>
 +<code bash>
 +curl --proto '=https' --tlsv1.2 -sSf https://sh.rustup.rs | sh
 +</code>
 +  *
 ===== Ressources ===== ===== Ressources =====
  
   *[[https://tutorials-raspberrypi.com/infrared-distance-measurement-with-the-raspberry-pi-sharp-gp2y0a02yk0f/|Blog post Tutorial]]   *[[https://tutorials-raspberrypi.com/infrared-distance-measurement-with-the-raspberry-pi-sharp-gp2y0a02yk0f/|Blog post Tutorial]]
  • composants/rpi_proxi_sensor.txt
  • Last modified: 2020/06/23 20:32
  • by mh