Differences

This shows you the differences between two versions of the page.

--- composants:rpi_proxi_sensor [2020/06/22 21:27] – [Wiring] mh
+++ composants:rpi_proxi_sensor [2020/06/23 20:24] – [Steps] mh
@@ Line 7: / Line 7: @@
 ==== Components ====
-  *Sharp 2Y0A21F Infrared sensor
+  *[[composants:2Y0A21|Sharp 2Y0A21F Infrared sensor]]
-  *MCP3008 ADC
+  *[[composants:mcp3008|MCP3008 ADC]]
+  *Raspberry Pi - any model
   *Breadboard, jumpers, etc.
@@ Line 15: / Line 16: @@
 {{composants:sharp_mcp_wiring.png?400}}
-|  RPi Pin #  ^  Role  ^  MCP3008 Pin #   ^  Role  |
+<WRAP 50%>
-|  1  |  3.3V  |  16  |  VDD  |
+|^  RPi Pin #^   ^Role  ^  MCP3008 Pin #^  ^Role  |
-|  1  |  3.3V  |  15  |  VREF  |
+|  1|    |3.3V|  16|  |VDD  |
-|  6  |  GND  |  14  |  AGND  |
+|  1|    |3.3V  |  15|  |VREF  |
-|  23  |  SLCK  |  13  |  CLK  |
+|  6|    |GND  |  14|  |AGND  |
-|  21  |  MISO  |  12  |  DOUT  |
+|  19|    |GPIO 10 (MOSI)  |  11|  |DIN  |
-|  19  |  MOSI  |  11  |  DIN  |
+|  21|    |GPIO 9 (MISO)  |  12|  |DOUT  |
-|  24  |  CE0  |  10  |  CS/SHDN  |
+|  23|    |GPIO 11 (SLCK)  |  13|  |CLK  |
-|  6  |  GND  |  9  |  DGND  |
+|  24|    |GPIO 8 (CE0)  |  10|  |CS/SHDN  |
+|  6|    |GND  |  9|  |DGND  |
+</WRAP>
+There are two different wirings, this one is for hardware SPI. Another one is used for software SPI
+{{composants:mcp3008pin.jpg?250}}
+===== Steps =====
+  *Installed raspbian
+  *Activated SPI in raspi-config
+  *wired a MCP3008 and a sharp IR module to the GPIO pins
+  *followed tuto on python but did not get data from module (read 0.00)
+  *rewired to software SPI (needs documenting)
+  *installed rust <FAILED>
+<code bash>
+curl --proto '=https' --tlsv1.2 -sSf https://sh.rustup.rs | sh
+</code>
+  *
 ===== Ressources =====
   *[[https://tutorials-raspberrypi.com/infrared-distance-measurement-with-the-raspberry-pi-sharp-gp2y0a02yk0f/|Blog post Tutorial]]