Show pageOld revisionsBacklinksFold/unfold allBack to top This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong. ====== Printing Tips & Techniques ====== ===== Cold casting 3D prints with metal powder ===== Found on this [[https://www.youtube.com/watch?v=7VBVU3FNt-s|youtube link]] * 3d print a part * Make a mold container (out of a plastic cup) and hot glue it to a support surface * Hot glue the part inside the container * Mix the two part resin in proper proportions * Pour it evenly and gently in the container to make the cast * Spray the mold with mold release * Mix iron powder with proper resin (ventilate, protect eyes and lungs) and add catalyst (dangerous) * Pour metal/resin mix gently and evenly in mold * When set, unmold * Tarnish and apply quick-rust * Tarnish again so the rust is only in the recessed details 3d-print/print-tips.txt Last modified: 2026/01/24 08:47by mh