3d:exercises:simple_house [mh8 Wiki]

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
{{:3d:exercises:3d-exercise-house.png?400|}}

==== Shortlist instructions ====

  * Dimensions 4 / 6 / 3.5
  * Roof
  * Chimney
  * Door cut-out + keep shape (cube)
  * Door knob (cylinder 8)
  * Windows cut-out + delete shape (cube mirrored)
  * Steps

==== Detailed instructions ====

  * Enable Viewport settings : Cavity / Both
  * Set dimensions 4 / 6 / 3.5
  * Set Z : 1.75
  * Extrude roof, merge at center (''M'')
  * Separate roof (''P'') and light scale on Y
  * Extrude roof along normals (Enable **Offset Even** option)
  * Bevel top roof edge and extrude sides along normals (O.2)
  * Create chimney : scale down, scale Z, Extrude top, Inset, extrude down
  * Create Loop cut on bottom of house for flooring (''CTRL'' + ''R'')
  * Select base face loop and extrude + scale out
  * Prepare a door cut-out shape and apply transformations to Door and House (''CTRL'' + ''A'')
  * Use Difference Boolean to cut door then delete excess mesh in house door.
  * Inset front face of door (disable **Boundary** option) and light extrude inside
  * Create door knob with a 8 sided cylinder, scale down and place on house
  * Create window cutout cube and place at proper depth
  * Set Origin point to 3D cursor (''RIGHT-CLICK'') (//3D Cursor should be at world origin//)
  * Mirror modifier along Y axis and boolean modifier on cubes
  * Delete cubes
  * Separate left window bottom face
  * Inset face, vertical loop cut x2 and scale down along Y axis (Use **option** tab)
  * Horizontal loop cut x2 and scale down along Z axis
  * Dissolve faces on the inset
  * Extrude created frame outwards
  * Delete other cut-out bottom face in house and mirror window to other side
  * Add two loop cuts to house base and scale down along Y
  * Extrude out to create upper step
  * Knife in the middle (''SHIFT'') and extrude bottom half to create bottom step