3d:modeling

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
3d:modeling [2025/09/12 09:13] – [Workflow] mh3d:modeling [2025/09/12 09:19] (current) – [Workflow] mh
Line 112: Line 112:
   * Start with a plane somewhere and extrude along the lines to match up the reference image. Look for poles where the edge flow needs to change direction (check the **[[3d:modeling:topology|Topology]]** page for more information).   * Start with a plane somewhere and extrude along the lines to match up the reference image. Look for poles where the edge flow needs to change direction (check the **[[3d:modeling:topology|Topology]]** page for more information).
  
-  * Details can be cut out of the model later so that they match up perfectly with the rest of the model.+  * Build the general outline first and then shapes can be cut out ensuring the topology matches up. 
 + 
 +  * Build the shapes roughly at first, loop cuts can be added in a second pass to refine the details. 
 + 
 +  * Use the **Smooth Vertices** command to average out the topology.
  
 ===== Stone Walls ===== ===== Stone Walls =====
  • 3d/modeling.1757661198.txt.gz
  • Last modified: 2025/09/12 09:13
  • by mh