Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
| 3d:modeling [2025/09/12 09:12] – mh | 3d:modeling [2025/09/12 09:19] (current) – [Workflow] mh | ||
|---|---|---|---|
| Line 111: | Line 111: | ||
| * Start with a plane somewhere and extrude along the lines to match up the reference image. Look for poles where the edge flow needs to change direction (check the **[[3d: | * Start with a plane somewhere and extrude along the lines to match up the reference image. Look for poles where the edge flow needs to change direction (check the **[[3d: | ||
| + | |||
| + | * Build the general outline first and then shapes can be cut out ensuring the topology matches up. | ||
| + | |||
| + | * Build the shapes roughly at first, loop cuts can be added in a second pass to refine the details. | ||
| + | |||
| + | * Use the **Smooth Vertices** command to average out the topology. | ||
| ===== Stone Walls ===== | ===== Stone Walls ===== | ||