Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
| 3d:modeling:topology [2025/04/16 18:38] – [Topology Flow] mh | 3d:modeling:topology [2025/04/16 18:38] (current) – [Topology Flow] mh | ||
|---|---|---|---|
| Line 10: | Line 10: | ||
| The second smaller zone is made by insetting the two faces with **'' | The second smaller zone is made by insetting the two faces with **'' | ||
| + | |||
| + | ---- | ||
| === Going from 3 to 1 === | === Going from 3 to 1 === | ||
| Line 18: | Line 20: | ||
| Notice the 180° turn on the edge flow again. | Notice the 180° turn on the edge flow again. | ||
| + | |||
| + | ---- | ||
| === Connecting 3 planes === | === Connecting 3 planes === | ||
| Line 24: | Line 28: | ||
| Keeping quads in the mesh enables a better control over the shape afterwards. | Keeping quads in the mesh enables a better control over the shape afterwards. | ||
| + | |||
| + | ---- | ||