Differences

This shows you the differences between two versions of the page.

--- 3d:modeling:topology [2025/04/16 18:37] – [Topology Flow] mh
+++ 3d:modeling:topology [2025/04/16 18:38] (current) – [Topology Flow] mh
@@ Line 10: / Line 10: @@
 The second smaller zone is made by insetting the two faces with **''B''** for boundaries activated.
+----
 === Going from 3 to 1 ===
 {{:3d:modeling:topology-flow-2.png?direct&300|}}
+This construction can bring 3 edges to a zone with one edge. Slide the middle edge inward, select the three edges and **''F''** to fill then the 1:1 edges and **''F''** to fill.
+Notice the 180° turn on the edge flow again.
+----
 === Connecting 3 planes ===
@@ Line 19: / Line 27: @@
 {{:3d:modeling:topology-flow-3.png?direct&300|}}
-This construction can bring 3 edges to a zone with one edge. Slide the middle edge inward, select the three edges and **''F''** to fill then the 1:1 edges and **''F''** to fill.
+Keeping quads in the mesh enables a better control over the shape afterwards.
+----
-Notice the 180° turn on the edge flow again.