3d:modeling:topology

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
3d:modeling:topology [2025/04/16 18:26] – [Topology Flow] mh3d:modeling:topology [2025/04/16 18:38] (current) – [Topology Flow] mh
Line 10: Line 10:
  
 The second smaller zone is made by insetting the two faces with **''B''** for boundaries activated. The second smaller zone is made by insetting the two faces with **''B''** for boundaries activated.
 +
 +----
  
 === Going from 3 to 1 === === Going from 3 to 1 ===
Line 18: Line 20:
  
 Notice the 180° turn on the edge flow again. Notice the 180° turn on the edge flow again.
 +
 +----
 +
 +=== Connecting 3 planes ===
 +
 +{{:3d:modeling:topology-flow-3.png?direct&300|}}
 +
 +Keeping quads in the mesh enables a better control over the shape afterwards.
 +
 +----
 +
  • 3d/modeling/topology.1744820798.txt.gz
  • Last modified: 2025/04/16 18:26
  • by mh