Differences

This shows you the differences between two versions of the page.

--- 3d:modeling:topology [2025/09/03 17:30] – mh
+++ 3d:modeling:topology [2025/09/09 14:32] (current) – [Topology] mh
@@ Line 1: / Line 1: @@
 ====== Topology ======
+=== Poles ===
 Edge flow is affected by the **poles** contained in a model. A **pole** is any vertex that has a number of connecting edges different than 4.
@@ Line 6: / Line 8: @@
 {{:3d:modeling:broken-edge-flow.png?direct&400|}}
+When modeling, you create poles when you need to redirect the edge flow, for example with some edges going towards the top and other edges going sideways.
+Select a part of the edges going up and extrude them upwards, then select the side edge thus extruded all the way down to the bottom edge and extrude those outwards.
+{{:3d:modeling:poles-redirect-edge-flow.png?direct&400}}
+=== Bevels and Crease ===
 On edges, bevels and crease can be used to create support topology.