Differences

This shows you the differences between two versions of the page.

--- projets:jozephine [2020/02/20 22:59] – [Arduino Code] mh
+++ projets:jozephine [2020/02/21 18:52] – [Arduino Code] mh
@@ Line 34: / Line 34: @@
 void loop()
 {
   fadeEyes(); // blink the eye thing
 }
 void fadeEyes()
 {
-  for (int i = 0; i < 312; i++) //unexplainable cycle value
+  analogWrite(led, brightness);
+  if (brightness == 255)
   {
-    analogWrite(led, brightness);
+    delay(1500); // stay a bit on full bright led
-    if (brightness == 255)
+  }
-    {
-      delay(750); // stay 3 seconds on full bright led
-    }
-    brightness = brightness + fadeAmount;
+  brightness = brightness + fadeAmount;
-    //reverse direction at start & end of fade
+  //reverse direction at start & end of fade
-    if (brightness == 0 || brightness == 255)
+  if (brightness == 0 || brightness == 255)
-    {
+  {
-      fadeAmount = -fadeAmount;
+    fadeAmount = -fadeAmount;
-    }
+  }
-    // wait 30 miliseconds to see changes
+  // wait 30 miliseconds to see changes
-    delay(30);
+  delay(30);
-  }
-  digitalWrite(led, LOW);
 }
 </code>
 ++++
-==== Upcoming ====
-  *fritzing diagram
-  *arduino code
+{{projets:jozephine_simple_leds.png?500}}
 ==== Legacy ====
@@ Line 138: / Line 127: @@
 ++++
+[[https://www.instructables.com/id/The-Creepy-Doll/|Instructables project]]