Differences

This shows you the differences between two versions of the page.

--- projets:jenny [2020/06/01 17:49] – [Pics] mh
+++ projets:jenny [2020/06/20 12:01] – [eMotronic (Smoothieboard) mainboard] mh
@@ Line 29: / Line 29: @@
 |  {{projets:jenny_i3.jpg?367}}  |  {{projets:jenny_i3_assembly.jpg?400}}  |
+|  Nearly completed  |  An early mess but operational  |
 ===== Upgrades =====
@@ Line 89: / Line 90: @@
 The board should bring an improvement to the quality of movement control which is essential in 3D printing and any CNC based solution.
+|  {{projets:jenny_new_fan_duct.jpg?300}}  |
+It requires supports to print but does it's job perfectly.
+----
+==== New Fan Duct ====
+I redesigned the fan duct of the radial fan cooling the print. The problem with the first design was the large flat bottom surface too close to the print that would hit on any print part warping during print.
 |  {{projets:unboxing_smoothieboard.jpg?300}}  |