Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
projets:jenny [2020/06/01 17:46] – [Next Steps] mh | projets:jenny [2020/06/20 12:01] – [eMotronic (Smoothieboard) mainboard] mh | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Jenny ====== | ====== Jenny ====== | ||
- | This is Jenny' | + | This is Jenny' |
===== Specs ===== | ===== Specs ===== | ||
Line 28: | Line 28: | ||
===== Pics ===== | ===== Pics ===== | ||
- | {{projets: | + | | |
+ | | Nearly completed | ||
===== Upgrades ===== | ===== Upgrades ===== | ||
Line 89: | Line 90: | ||
The board should bring an improvement to the quality of movement control which is essential in 3D printing and any CNC based solution. | The board should bring an improvement to the quality of movement control which is essential in 3D printing and any CNC based solution. | ||
+ | |||
+ | | {{projets: | ||
+ | |||
+ | It requires supports to print but does it's job perfectly. | ||
+ | |||
+ | |||
+ | |||
+ | ---- | ||
+ | |||
+ | ==== New Fan Duct ==== | ||
+ | |||
+ | I redesigned the fan duct of the radial fan cooling the print. The problem with the first design was the large flat bottom surface too close to the print that would hit on any print part warping during print. | ||
| {{projets: | | {{projets: |