Differences

This shows you the differences between two versions of the page.

--- projets:jenny [2020/06/01 17:45] – [eMotronic (Smoothieboard) mainboard] mh
+++ projets:jenny [2020/06/20 12:02] – mh
@@ Line 1: / Line 1: @@
 ====== Jenny ======
-This is Jenny's project page, created when I upgraded Jenny from a Prusa Mendel i2 to an i3
+This is Jenny's project page, created when I upgraded Jenny from a Prusa Mendel i2 to an i3.
 ===== Specs =====
@@ Line 28: / Line 28: @@
 ===== Pics =====
-{{projets:jenny_i3.jpg?400}}{{projets:jenny_i3_assembly.jpg?400}}
+|  {{projets:jenny_i3.jpg?367}}  |  {{projets:jenny_i3_assembly.jpg?400}}  |
+|  Nearly completed  |  An early mess but operational  |
 ===== Upgrades =====
@@ Line 99: / Line 100: @@
 She also has brand new stepper motors for controlling X, Y and Z.
+----
+==== New Fan Duct ====
+I redesigned the fan duct of the radial fan cooling the print. The problem with the first design was the large flat bottom surface too close to the print that would hit on any print part warping during print.
+|  {{projets:jenny_new_fan_duct.jpg?300}}  |
+It requires supports to print but does it's job perfectly.
+  *__**Files :**__
+  *__**Design :**__ mh8
 ----
@@ Line 106: / Line 120: @@
   *Try some new gcode on print stop line 1050 of configuration_adv.h (try multiple successive commands)
-  *Design a new exhaust piece for cooler radial fan