Differences

This shows you the differences between two versions of the page.

--- projets:jenny [2020/06/01 17:45] – [eMotronic (Smoothieboard) mainboard] mh
+++ projets:jenny [2020/06/20 12:01] – [eMotronic (Smoothieboard) mainboard] mh
@@ Line 1: / Line 1: @@
 ====== Jenny ======
-This is Jenny's project page, created when I upgraded Jenny from a Prusa Mendel i2 to an i3
+This is Jenny's project page, created when I upgraded Jenny from a Prusa Mendel i2 to an i3.
 ===== Specs =====
@@ Line 28: / Line 28: @@
 ===== Pics =====
-{{projets:jenny_i3.jpg?400}}{{projets:jenny_i3_assembly.jpg?400}}
+|  {{projets:jenny_i3.jpg?367}}  |  {{projets:jenny_i3_assembly.jpg?400}}  |
+|  Nearly completed  |  An early mess but operational  |
 ===== Upgrades =====
@@ Line 89: / Line 90: @@
 The board should bring an improvement to the quality of movement control which is essential in 3D printing and any CNC based solution.
+|  {{projets:jenny_new_fan_duct.jpg?300}}  |
+It requires supports to print but does it's job perfectly.
+----
+==== New Fan Duct ====
+I redesigned the fan duct of the radial fan cooling the print. The problem with the first design was the large flat bottom surface too close to the print that would hit on any print part warping during print.
 |  {{projets:unboxing_smoothieboard.jpg?300}}  |
@@ Line 106: / Line 119: @@
   *Try some new gcode on print stop line 1050 of configuration_adv.h (try multiple successive commands)
-  *Design a new exhaust piece for cooler radial fan