Differences
This shows you the differences between two versions of the page.
Next revision | Previous revisionLast revisionBoth sides next revision | ||
materiaux:start [2018/04/18 00:12] – created mh | materiaux:start [2019/04/28 17:21] – [Filaments d'impression] mh | ||
---|---|---|---|
Line 18: | Line 18: | ||
==== Filaments d' | ==== Filaments d' | ||
*[[materiaux: | *[[materiaux: | ||
- | *[[materiaux: | + | *[[materiaux: |
+ | *[[materiaux: | ||
*Ninja flex | *Ninja flex | ||
*PLA Phosphorescent | *PLA Phosphorescent | ||
*[[materiaux: | *[[materiaux: | ||
+ | |||
+ | If a spool of filament has taken humidity put it in the oven at 60°C for an hour or two to dehydrate it. | ||
+ |