Differences

This shows you the differences between two versions of the page.

--- composants:i2c_oled_ssd1306 [2019/01/06 19:27] – [Utilisation] mh
+++ composants:i2c_oled_ssd1306 [2019/08/13 21:35] – [Usage] mh
@@ Line 1: / Line 1: @@
 ====== I2C OLED 0.91 inch Screen ======
-===== Résumé =====
+Exists in various format (128x32, 128x64)
-Un petit écran qui utilise le driver SSD1306. S'interface avec 2 fils (I2C). Existe en format 128x32 ou 128x64.
+{{composants:0.91lcd.jpg?300}}
-===== Utilisation =====
+===== Specifications =====
-Dans Arduino il y a plusieurs bibliothèques qui permettent de s'interfacer en I2C avec des modules.
+  *5V ready
+  *Can use I2C (two wires) or SPI communication
-Il faut d'abord trouver l'adresse I2C du module en utilisant un program scan via une arduino.
+===== Usage =====
+You can use **Adafruit SSD1306**.
+The 128x32 uses address 0x3C
+If you are connecting to SDA/SCL using I2C connect pin SDA to UNO A4 and SCL to UNO A5 (default pins, respectively 20 and 21 on a Mega)
+++++ Basic Arduino text example |
+<code c>
+#include <SPI.h>
+#include <Wire.h>
+#include <Adafruit_GFX.h>
+#include <Adafruit_SSD1306.h>
+#define SCREEN_WIDTH 128 // OLED display width, in pixels
+#define SCREEN_HEIGHT 32 // OLED display height, in pixels
+// Declaration for an SSD1306 display connected to I2C (SDA, SCL pins)
+#define OLED_RESET     4 // Reset pin # (or -1 if sharing Arduino reset pin)
+Adafruit_SSD1306 display(SCREEN_WIDTH, SCREEN_HEIGHT, &Wire, OLED_RESET);
+void setup() {
+  Serial.begin(9600);
+  // SSD1306_SWITCHCAPVCC = generate display voltage from 3.3V internally
+  if(!display.begin(SSD1306_SWITCHCAPVCC, 0x3C)) { // Address 0x3C for 128x32
+    Serial.println(F("SSD1306 allocation failed"));
+    for(;;); // Don't proceed, loop forever
+  }
+}
+void loop() {
+  writeText();
+}
+void writeText(void) {
+  display.clearDisplay();
+  display.setTextSize(1);             // Normal 1:1 pixel scale
+  display.setTextColor(WHITE);        // Draw white text
+  display.setCursor(0, 0);            // Start at top-left corner
+  display.println(F("Hello, world!"));
+  display.display();
+}
+</code>
+++++
 ===== Ressources =====
-Acheté de la marque MakerHawk en chine.
+Bought from MakerHawk in chine.
+  *[[https://projetsdiy.fr/ssd1306-mini-ecran-oled-i2c-128x64-arduino/|DIY Project for SSD1306 OLED I2C]]