Differences

This shows you the differences between two versions of the page.

--- composants:attiny85 [2019/08/13 19:11] – [Wiring] mh
+++ composants:attiny85 [2020/06/01 16:35] (current) – external edit 127.0.0.1
@@ Line 11: / Line 11: @@
 Also, the ATtiny85 runs by default at 1MHz so if you want it to run at 8MHz you need to burn the bootloader into it after having selected the appropriate frequency.
-//**Note :** Arduino in the past did not support ATtiny by default and additional libs had to be provided. Sooner or later this might not be the case anymore.//
+<WRAP info round 95>
+**Note :** Arduino in the past did not support ATtiny by default and additional libs had to be provided.
+Sooner or later this might not be the case anymore.
+</WRAP>
 The Arduino UNO should be flashed with the ISP program : File > Examples > ArduinoISP
@@ Line 23: / Line 28: @@
 Set Arduino to ISP, usually located in the IDE in Tools > Programmer > Arduino as ISP
-You can add Green/Red/Blue (or choose your colors) leds respectively on 9, 8, 7 respectively Heartbeat, Error, Programming
+You can add Heartbeat, Error, Programming LEDs (choose your colors) respectively on 9, 8, 7.
-**For the moment i'm having trouble uploading to it and I'm missing the 10μF electrolytic capacitor.**
@@ Line 33: / Line 38: @@
   *[[https://create.arduino.cc/projecthub/arjun/programming-attiny85-with-arduino-uno-afb829|Basic programming tutorial]]
+  *[[https://www.re-innovation.co.uk/docs/sleep-modes-on-attiny85/|Sleep Mode tutorial]]